Property

■ High solid content，Zero formaldehyde

■ Wear-resistant and anti-slip

■ Excellent weather resistance, suitable for both indoor and outdoor use.

Aapplications

The anti-slip floor coating is widely used in workshops, parking lots, shopping malls, canteens, balconies, and office spaces.

Physical parameters

Colour：                                       Meets customer requirements

Weight solid fraction:               ≥85%

Flash point (° C)

A：                                                 About 105

B：                                                 about 70

Viscosity:                                       50-300 CPS(25℃, initial mixing of two components)

Specific Gravity:                          -g/cm³

Gloss:                                             High gloss 

Suggested usage amount:     0.1-0.12KG/m²，Suggest construction twice

Index

Elongation ：                                  /

Tensile strength:                             /

Adhesion（concrete）:                ≥2.5 MPa or substrate failure                   

Wear resistance (750g/500r)：  ≤15mg

Hardness:                                        3H

Construction parameters

Use ratio:                                         A:B:C:D=5：1：1：2.5(Weight ratio, stir well before use)

Construction conditions:

Ambient temperature:               5℃-30℃

ambient humidity:                      ≤85%

Substrate temperature:             Must be greater than the air dew point temperature of 3℃ or more

Construction method:               Batch coating first, then roll coating

Cleaning agent:                           Matching standard diluent

The provided data is for guidance only.  The actual drying time/paint application interval may vary and can be longer or shorter, depending on factors such as film thickness, ventilation conditions, humidity, underlying paint, and the need for early loading and unloading.

Coating Compatibility

Epoxy self leveling flat paint, self leveling elastic paint or refer to our recommended matching primer.

Mixing Instructions

Mix the materials strictly according to the provided ratios.

When mixing, first gently stir the A-component before proceeding with the mixing.

For improved accuracy in mixing, it is recommended to use an electronic scale for precise weighing.

After mixing A,B,C and D, ensure thorough mixing with a mixer before application; otherwise, there may be areas of the coating that do not dry properly.

Surface Preparation

Ensure the surface is clean and dry before construction.

Pay attention to the interval between the application of the primer and the topcoat.

Storage

Storage time:                    1 year        

Storage temperature:  0℃-30℃.

PACKING

A：2.6kg    B：0.52 kg     C：0.52kg     D：1.36kg

Safety Measures

1. Avoid contact with skin and eyes.
2. If paint comes into contact with the skin, wash with an appropriate detergent.If paint comes into contact with the eyes, rinse with plenty of water and seek medical attention immediately.
3. Ensure good ventilation at the construction site.
4. The paint contains flammable substances; keep away from sparks and prohibit   
5. Smoking in the vicinity of the work area.
6. Comply with all health and safety regulations on site.

Declaration

The information provided in this product manual is based entirely on data obtained from our laboratory and practical experience.  However, as the actual use of the product is usually beyond our control, we only guarantee the quality of the product itself.  We reserve the right to modify this manual without prior notice.