Product characteristics：

■ Excellent weather resistance, with a service life of more than 20 years.

■ Excellent adhesion to a variety of substrates.

■ Excellent tensile elongation and tensile strength.

■ Excellent waterproofing and decorative functions.

Designed for use:

Mainly used for waterproof repair of exterior walls of buildings, and can also be used for waterproof construction of open-air balconies and corridors.

Physical parameters：

Colour：                  Colorless or yellowish transparent liquid

Weight solid fraction:         ≥80%

Flash point (° C)

A：               about 70

B：               about 75

Viscosity:                            500-1500CPS(25℃, initial mixing of two components)

Specific Gravity:               1.05±0.03g/cm³

Gloss:                                  High gloss

Coating film thickness:  

 Ground coating thickness： 250－350μm

 Wall coating thickness：       100-150 μm  

Theoretical coating rate:         3.5-4 m²/Kg（200μm）

Coating film main technical indicators：

Elongation ：              ≥250%

Tensile strength:             ≥10MPa

Tear strength:               ≥50N/mm

Adhesion (tile) :             ≥10MPa         

Wear resistance (750g/500r)：  ≤30mg

Construction parameters:：

Use ratio:                   A:B=1:1(Weight ratio, stir well before use)

Construction time available：

Construction conditions:

Ambient temperature:          5℃-30℃

Ambient humidity:                 ≤85%

Substrate temperature:         must be greater than the air dew point temperature of 3℃ or more

Construction method:           brush, roll or spray.

Cleaning agent:                       matching standard diluent

Drying time and coating interval：

The provided data is for guidance only.  The actual drying time/paint application interval may vary and can be longer or shorter, depending on factors such as film thickness, ventilation conditions, humidity, underlying paint, and the need for early loading and unloading.

Coating Compatibility：

Suitable primer: Direct application on the treated substrate surface.

Mixing Instructions：

Mix the materials strictly according to the provided ratios.

When mixing, first gently stir the A-component before proceeding with the mixing.

For improved accuracy in mixing, it is recommended to use an electronic scale for precise weighing.

After mixing A and B, ensure thorough mixing with a mixer before application; otherwise, there may be areas of the coating that do not dry properly.

Surface Preparation：

Rinse off salts and other water-soluble impurities with clean water.

Remove grease with appropriate cleaners and degreasers.

Ensure the surface is clean and dry before construction.

Pay attention to the interval between the application of the primer and the topcoat.

Storage:：

Storage time:         Paint: 1 year,        Hardener: 1 year.

Storage temperature:  0℃-30℃.

PACKING:

Paint: 10KG/1KG/0.5KG   Hardener: 10KG/1KG/0.5KG

Safety Measures：

1. Avoid contact with skin and eyes.
2. If paint comes into contact with the skin, wash with an appropriate detergent.If paint comes into contact with the eyes, rinse with plenty of water and seek medical attention immediately.
3. Ensure good ventilation at the construction site.
4. The paint contains flammable substances; keep away from sparks and prohibit.
5. smoking in the vicinity of the work area.
6. Comply with all health and safety regulations on site.

Declaration：

The information provided in this product manual is based entirely on data obtained from our laboratory and practical experience.  However, as the actual use of the product is usually beyond our control, we only guarantee the quality of the product itself.  We reserve the right to modify this manual without prior notice.